Set Vidio id

HCG RX Mixing Instructions

HCG Mixing Instructions for Injection Method

HCG RX Mixing Instructions for Injections

I had done a Video showing a HCG being mixed

but  thought it would help to post the 10 easy steps along with pictures 

HCG Mixing Supplies

 

Supplies

 

 

 

Supply List

Alcohol Prep Pads  

Bacteriostatic Water – 1 Bottle Bacteriostatic Sterile Water for Injection, 30ml USP (sometime referred to as “Bac Water”)

Mixing Vial – 1 – Sterile Empty Vial 10ml

Mixing Syringe – 3ML SYRINGE/NEEDLE 25 Gauge (but you can also just use on of the insulin needles)

Diabetic syringes , .5cc, 30 gauge, 5/16″ needle (You will need enough to use one per day)

Buy HCG Online

My favorite “GO TO” for ordering RX HCG :

Reliablerxpharmacy

HCG comes in different brand names – I have used Hucog, Corion, and Noverall

 

 

10 Easy Step by Step HCG Mixing Instructions:

 

1 – Make sure you are working on a sterile surface and do not touch your needle back to any surface after you start, to keep it sterile

 

2 – Remove the plastic tab lid off of the Bacteriostatic water (30 ml container with the pink lid) and off the HCG (you will see powder or what looks like a small white tablet in the bottom of the very small HCG vial).

 

3 – Then clean the tops of the sterile vial (sterile vial has a shiny green metal lid with a rubber stopper in the center), the bacteriostatic water and the HCG with an alcohol wipe.

Vial of HCG before mixing

HCG Vial

 

4 – Pull up the plunger on your large mixing syringe to 1 ml.  Then put the needle into the bacteriostatic water and inject the air into the water.  Then immediately pull out 1 ml of water.  (It works best if you put the bottle upside down, with the needle underneath the bottle and pull the water out).

 

 

5 – Inject that water into the vial of HCG slowly and then withdraw 1 ml of air from the hCG vial, being careful not to draw out any of the liquid.

 

6 – Swirl HCG vial gently DO NOT SHAKE to completely reconstitute the hCG, with out shaking.  This avoids adding too many air bubbles.

 

7 – Draw out the liquid HCG, using your mixing syringe again.  Hold the hCG vial upside down and needle underneath the HCG, with just barely the tip of the needle into the bottle, so that you can get out all the HCG.

 

mix ml bac water 150x150

1 ml bac water

 

 

8 – Then, inject the 1 ml of liquid HCG into your sterile mixing vial.

 

 

 

 

9 – Pull out 3 ml of bacteriostatic water 3 times for a total of 9 ml of Bac water added to the 1 ml of HCG in the mixing vial  (use the  method of the bottle upside down and your needle underneath, when you draw out the water.)

bac water

Add 3 ml bac water 3X

 

 

 

10 – Now that the HCG is mixed it must be kept refrigerated. Store in a safe area of the fridge where the cold temperature will be most consistent.I also like to wrap the vial with foil to also help insulate it.

 

 

 

hcg syringe ready for injection

HCG Dose Example

I prefer to load the syringe just past the “20” mark but less that “25” That seems to be my “sweet spot” . You may need to adjust depending on if you experience hunger etc.

 

I have always purchased the 5000 iu which will mix for a 40 day round. If you want to freeze after mixing you can as long as you load the individual syringes then freeze.

 

 

Note  – There is another mixing method that uses less Bac water. I tried that mixing method which is using 5 ml instead of 10.

I did the 5ML Bac Water the last recent rounds that were quite some time ago now (I did it to save on the bac water).

I dosed lower at around 15-20 till I found my “sweet spot” once again.I didn’t have a lot of weight to lose and got to goal well before the 23 day round completed. I think less fat to lose and HCG potency allowed for lower dosing.

Every body is different so I am just letting you know my personal experience.

See How to Mix the HCG for your round

Google Ads

If you would like to support my website and pups!

Twitter

Archives

HCG Cooking Tips